CRCA MEDIUM CARBON STEEL STRIPS
Meduim Carbon Steels are similar to low carbon steel except that the carbon ranges from 0.30 to 0.60% & the manganese from 0.50 to .70%. Increasing the carbon content is approximately 0.5% with an accompanying increase in manganese allows medium carbon steels to be used in the quenched & tempered conditions. This steels are of particular importance because of unique combination of strength & toughness after heat treat treatment.
We offer the following Grades :-
Chemical Composition |
||||||||
Grade | %C | %Si | %Mn | %S | %P | |||
C-40 | 0.35 -0.45 | 0.10.- 0.35 | 0.60-0.90 | 0.05 max | 0.05 max | |||
C-55 | 0.50-0.60 | 0.10.- 0.35 | 0.50 - 0.65 | 0.05 max | 0.05 max | |||
C-65 | 0.60-0.70 | 0.10.-0.35 | 0.50-0.80 | 0.05 max | 0.05 max |
Range |
|
Width: | 8 mm to 500 mm |
Thickness: | 0.10 mm to 6.00 mm |
Hardness: | Fully annealed or rolling hard as per customer requirement. |
Surface Finish: | Bright |
Form of supply:Materials are supplied in coil form. If any special I.D. & O.D. requirements are there, that can be maintained. Further, material can also be supplied in cut lengths, if required by the customer.
Applications: Defence Products, Pen Clips, Hair Clips, Automotive Seat Belt, High Tensile Steel Strapping, Safety Toe Cap, Drums, Washers .etc.